ALCOHOL MOLULE SPECIFICATION
Detecting point: 0.25mg/l (can be changed). (0.05% BAC US, 0.5% BAC UK; preset from us). Operating temperature range: 0°C ~ 40°C.
Size: 78mm x 40mm x 23mm
Weight: 30g, excluding batteries.
Indicating way: red color LED.
Warm-up time: less than 10 seconds.
Batteries: 3V DC (2 x AAA batteries).
After completing testing, please close the power supply avoiding battery sources waste. During the testing, when the yellow LED on, it means the battery exhausted and need to replace.
- Input 2 pcs AAA 1.5V battery into the module.
- Push up the switch to the "test" position, the green and yellow LED on. The yellow LED will light during warm-up, 10 seconds later, the yellow LED will black out, only green LED lights, the tester enter detecting status.
- Face to the gas entrance on top of the module, you can breath out gas directly, the tester will detect and indicate the alcohol concentration in the breathed gas. If the alohol concentration in your blood < 0.05% BAC (pre-set level). Than will not have LED turn on. It means alcohol concentration in your blood > 0.05% BAC, the Red LED on the module will light on.
- Push down the power supply switch to "Lamp", the LED light on for lighting function. In the lighter state the system without detecting function.
Same function with AT110M1. But change the switch to push button. When you push the button the module will power on and pre-heat to ready than waiting for detecting. Push button also will turn on the lighter function.
Ralease the power button than the system and lighter function will turn off.
Similar function with AT110M2. But just for two LED and no lighter function. Button cell to instead of AAA battery will be accpepable. But operating time is much shorter than AAA battery source.
Push the button for power on and pre-heat wystem than to ready for test. In the pre-heating state, the RED LED will light on. After complete the pre-heating state, the RED LED will turn off. If the sensor detect the concentration oer the pre-set level than the RED LED will light on again. User should push button continuously during the operating period.
Release the button the system will turn off.
Notification for the mentioned 3 modules.
- If there is much disturb gas exit in the detecting area, it may inflence the testing accuracy.
- As different people has different endurance, this testing result only for reference, not for a subject standard for driving.